Integrate network device into company network | Reset to company standard

Set network device to DHCP

Integrate device into FL Dante network (with DHCP router)

The device receives an IP address within the FL network and is discoverable by service/control devices

Identify device and apply company IP configuration:

DANTE Primary: static
VLAN 10.16.8.0/22
– FL-Devices: take the DANTE primary IP address of the device from the IP-Table: Audio – Dante Primary | Control | RF
– External temporary devices: take the QuickAdd address from the IP-Table: Audio – Dante Primary | Control | RF or leave on DHCP

DANTE Secondary: DHCP (LinkLocal for Lake)
VLAN 169.254.x.x/16
corresponds ZeroConf/LinkLocal, as there is no DHCP server in the network

Control: static
VLAN 10.16.8.0/22 (= DANTE Primary)
– FL devices: take the Control IP address of the device from the IP-Table: Audio – Dante Primary | Control | RF
– External temporary devices: take the QuickAdd adress from the IP-Table: Audio – Dante Primary | Control | RF or leave on DHCP

Special case Yamaha consoles:
MixerControl: static
VLAN 10.16.12.0/23
– FL devices: take the Control IP address of the device from the Yamaha Control IP table
– External temporary devices: take the QuickAdd adress from the Yamaha Control IP table

Update / adjust documentation in the IP table if necessary

Restore Dante names and (audio) settings