Integrate network device into company network | Reset to company standard

• 1

  Set network device to DHCP

• 2

  Integrate device into FL Dante network (with DHCP router)

  The device receives an IP address within the FL network and is discoverable by service/control devices

• 3

  Identify device and apply company IP configuration:

  DANTE Primary: static
  VLAN 10.16.8.0/22
  – FL-Devices: take the DANTE primary IP address of the device from the IP-Table: Audio – Dante Primary | Control | RF
  – External temporary devices: take the QuickAdd address from the IP-Table: Audio – Dante Primary | Control | RF or leave on DHCP

  DANTE Secondary: DHCP (LinkLocal for Lake)
  VLAN 169.254.x.x/16
  corresponds ZeroConf/LinkLocal, as there is no DHCP server in the network

  Control: static
  VLAN 10.16.8.0/22 (= DANTE Primary)
  – FL devices: take the Control IP address of the device from the IP-Table: Audio – Dante Primary | Control | RF
  – External temporary devices: take the QuickAdd adress from the IP-Table: Audio – Dante Primary | Control | RF or leave on DHCP

  Special case Yamaha consoles:
  MixerControl: static
  VLAN 10.16.12.0/23
  – FL devices: take the Control IP address of the device from the Yamaha Control IP table
  – External temporary devices: take the QuickAdd adress from the Yamaha Control IP table

• 4

  Update / adjust documentation in the IP table if necessary

• 5

  Restore Dante names and (audio) settings

Nothing Found